Instale a grelha frontal e encaixe

Instale a grelha frontal e encaixe com firmeza os ganchos superiores (3 localizações) e os ganchos do laterais direitos e esquerdos (3 localizações cada).

Monte a alheta (grande).

Baixe o painel frontal inferior para a sua posição original.

Fixe os chicotes de fios aos 2 conectores e fixe os chicotes de fios com a presilha de fio.

Instale o filtro de ar e, seguidamente, monte o painel frontal superior.

Ganchos laterais

Remova o painel frontal superior e a grelha frontal. (4 parafusos)

Corte a ponte de endereço (J4) no controlador remoto.

Cuidado para não cortar a ponte (J8).

Remova o painel frontal superior e a grelha frontal. (4 parafusos)

Remova o conector montado de origem de S21.

Amarre os chicotes num feixe conforme indicado na ilustração para que o conector removido não interfira com a placa do circuito impresso.

結果 (英語) 1:

install the front grille and lock firmly the upper hooks (3 locations) and the hooks of the right and left sides (3 locations each).

lot to lug (great).

download the lower front panel to its original position .

attach harnesses to attach the 2 connectors and harnesses with wire clip.

install the air filter and thenmount the upper front panel.



side hooks remove the upper front panel and front grille. (4 screws)

cut the bridge address (J4) on the remote controller.

Careful not to cut the bridge (j8).

Remove the upper front panel and front grille. (4 screws)

remove the connector mounted source s21.

mooring whips a beam as shown in the illustration to remove the connector does not interfere with the printed circuit board.

結果 (英語) 2:

Install the front Grill and attach firmly the upper hooks (3 locations) and the hooks on the right and left side (3 locations each).

Mount the tree (big).

download the lower front panel to its original position.

secure the harnesses to 2 and secure the connectors harnesses with wire clip.

Install the air filter andSubsequently, mount the front panel top.

lateral Hooks

Remove the top front panel and the front Grill. (4 screws) Cutting

to address bridge (J4) on the remote controller.

careful not to cut the bridge (J8).

Remove the top front panel and the front Grill. (4 screws)

Remove the mounted connector S21 source.

Mooring whips a beam as shown in the illustration so that the connector removed do not interfere with the printed circuit board.

結果 (英語) 3:

Install the front grille and snap with firmness the top hooks (3 locations) and the hooks on the left-hand and right-hand side (3 locations each) .

Mount the blade (large) .

Download the lower front panel to its original position.

Attach the wire harnesses to 2 connectors and attach the wire harnesses with the wire clip.

Install the air filter and, subsequently,Mount the upper front panel.

side Hooks

Remove the upper front panel and front grille. (4 Bolts)

Cut the bridge of address (J4) on the remote controller.

Taking Care not to cut the jumper (J8) .

Remove the upper front panel and front grille. (4 Bolts)

Remove connector mounted origin of S21.

Fasten the harnesses a beam as indicated in the illustration for the connector removed does not interfere with the printed circuit board.